HP — Installing the head board

Figure 179: Rear head board cable locations Disconnect the 3 cables 15. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, remove the 4 head board mounting screws. See Figure 180. Figure 180: Remove the head board mounting screws Remove the head board mounting screws Installing the head board 1. Align the head board with the mounting holes. 2. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, reinstall the 4 mounting screws. 3. Reconnect the substrate sensor cable and the 2 filament motor cables to the rear of the head board. 4. Feed the toggle sensor cable through the head board. 5. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, reinstall the toggle sen- sor wire clips. 6.

Reconnect the toggle sensor cable to the toggle sensor. 7. Reconnect the toggle sensor cable to the head board. 8. Reconnect the model and support heater cables. 9. Reconnect the umbilical cable. 10. Place the thermocouple wires in the wire retaining clip. 11. Reconnect the model and support material tubes. 12. Reinstall the air plenum. 13. Reinstall the head cover. 14. Reinstall the right side access cover. 15. Reinstall the side panels. See “Installing the side panels” on page 164 16. Reinstall the top panel. See “Installing the top panel” on page 162 -238