HP — Removing the TC Amp board

TC Amp board Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver • 1 ⁄ 4 ” nut driver Hardware • 10-32 x 3 ⁄ 8 ” slotted screws (x7) • 6-32 x 1 ⁄ 4 ” slotted screws (x3) Removing the TC Amp board 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the right side access panel mounting screws with a 5 ⁄ 16 ” nut driver or standard screwdriver and remove the panel. See Figure 181. Figure 181: Right side access panel mounting screw locations Remove the 7 mounting screws. 4. Disconnect the umbilical cable by pressing in on the tab and pulling out- ward. See Figure 182. -239