HP — Removing the TC Amp board

Figure 182: Disconnecting the umbilical cable Disconnect the umbilical cable 5. Disconnect the model and support thermocouple wires by pulling out- ward. See Figure 183. Figure 183: Thermocouple wire locations Disconnect the support thermocouple Disconnect the model thermocouple 6. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, remove the 3 mounting screws and remove the TC Amp board. See Figure 184. Figure 184: TC Amp board mounting screw locations Remove the 3 mounting screws -240