Installing the TC Amp board 1. Align the TC Amp board with the mounting holes. 2. Using a 1 ⁄ 4 ” nut driver or standard screwdriver, reinstall the 3 mounting screws. 3. Reconnect the model and support thermocouple wires. 4. Reconnect the umbilical cable. 5. Reinstall the right side access panel. 6. Reinstall the side panels. See “Installing the side panels” on page 164 7. Reinstall the top panel.
See “Installing the top panel” on page 162 Umbilical Hose Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver • 1 ⁄ 4 ” nut driver • 5 ⁄ 32 ” allen wrench • Cutters Hardware • Wire tie • 10-32 x 3 ⁄ 8 ” slotted screws (x7) • 1 ⁄ 4 - 20 x 1 ⁄ 2 ” button head cap screws (x2) Removing the umbilical hose 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the right side access panel mounting screws and remove the panel. See Figure 185. -241