HP — Installing the X motor

Figure 206: X motor mounting bracket mounting screw locations Remove the 4 mounting screws 11. Using a 9 ⁄ 64 ” allen wrench, remove the 4 X motor mounting screws from the mounting bracket. See Figure 207. Figure 207: X motor mounting screw locations Remove the 4 mounting screws 12. Remove the X motor from the X motor mounting bracket. Installing the X motor 1. Place the X belt around the X motor pulley. 2. Align the X motor into the X motor mounting bracket making sure the X motor cable faces the front of the printer. 3. Using a 9 ⁄ 64 ” allen wrench, reinstall the 4 X motor mounting screws. 4. Align the X motor mounting bracket with the mounting holes. 5.

Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 4 X motor mounting bracket mounting screws. -256