HP — Installing the X motor

6. Align the X motor energy chain mounting bracket with the mounting holes. 7. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 2 X motor energy chain mounting screws. 8. Reconnect the X motor cable. 9. Reinstall a wire tie around the X motor cable connector. See Figure 208. Figure 208: X motor wire tie locations Reinstall wire tie 10. Move the Head Assembly to the full right travel position within the build envelope (as viewed from the front of the printer). 11. Insert the zero gauge block into the gauge. See Figure 209. 12. Loosen the adjustment screw and slide the dial indicator assembly up or down to set the ‘zero’ reading:

The large hand should be on 0 and the small hand on 5. 13. Tighten the adjustment screw (do not over tighten the screw) and recheck the reading. 14. Remove the zero block gauge block from the fixture. -257