HP — Installing the Y motor

Figure 216: Y motor mounting screw locations Remove the 4 mounting screws 8. Remove the Y motor. Installing the Y motor 1. Align the Y motor with the Y motor mounting bracket, making sure the Y motor cable faces the back of the printer. 2. Using a 9 ⁄ 64 ” allen wrench, reinstall the 4 Y motor mounting screws. 3. Align the Y motor mounting bracket with mounting holes. 4. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, loosely reinstall the Y motor mounting bracket mounting screws. 5. Place the Y motor belt around the Y motor pulley. 6. Slide the Y motor mounting bracket up until the Y belt is tight. 7.

Using a 5 ⁄ 16 ” nut driver or standard screwdriver, securely fasten the Y motor mounting bracket mounting screws. 8. Reconnect the Y motor cable. 9. Align the left side access panel with the mounting holes. 10. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the left side access panel mounting screws. 11. Reinstall the upper electronics bay cover. See “Installing the upper elec- tronics bay cover” on page 174 13. Reinstall the top panel. See “Installing the top panel” on page 162 12. Reinstall the side panels. See “Installing the side panels” on page 164 -262