HP — Removing the Y Motor Belt

Figure 217: Left side access panel mounting screw locations Remove the 7 mounting screws. 5. Disconnect the material bay cable from the printer. 6. Remove the Front Panel. See “Removing the front panel” on page 166 7. Remove the Electronics Bay. See “Removing the Electronics Bay” on page 175 8. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the right side access panel mounting screws and remove the right side access panel. See Figure 218. Figure 218: Right side access panel mounting screw locations Remove the 7 mounting screws. 9. Using a 5 ⁄ 16 ” box wrench, remove the outer Y belt retaining clip mount- ing screws from the left side. See Figure 219. 10.

Using a 5 ⁄ 16 ” box wrench, loosen, but do not remove, the inner Y belt retaining clip mounting screws from the left side. See Figure 219. 11. Pull the left side Y belt out from the retaining clip. -264