HP — Removing the XY table

Figure 247: Umbilical hose wire tie location Cut and remove the wire tie 10. Using a 5 ⁄ 32 ” allen wrench, remove the 2 energy chain mounting screws. See Figure 248. Figure 248: Energy chain mounting screw locations Remove the 2 mounting screws 11. Remove the substrate sensor. See “Removing the substrate sensor” on page 220 12. Using a 1 ⁄ 2 ” box wrench, remove the X belt tension adjuster by loosen- ing the inside nut and then backing the bolt out of the mount. See Figure 249. 13. Remove the tensioning fork and pulley from the X motor belt. -284