Figure 267: XY Table alignment bracket mounting locations Place an alignment bracket at the front of the printer Place an alignment bracket at the back of the printer 44. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, loosen but do not remove the left side X guide rod mounting screws. 45. Center the Y guide rods in the mounting slots and loosely tighten. See Figure 268. Figure 268: Center Y guide rods Position the Y guide rods so the screw and washer are in the center 46. Slide the translator to the left side of the printer. 47. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, securely fasten the left side X guide rod mounting screws. 48.
Slide the translator to the right side of the printer. 49. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, securely fasten the right side X guide rod mounting screws. -295 WARNING: Failure to center the Y guide rods before tightening the X guide rod screws will result in X guide rod misalignment.