30. Using a 5 ⁄ 16 ” box wrench, tighten the right side Y belt clamp mounting screws. 31. Using a 5 ⁄ 16 ” box wrench, tighten the left side Y belt clamp mounting screws. 32. Using a 5 ⁄ 32 ” allen wrench, securely fasten the left rear Y guide rod mounting screw. 34. Reinstall the TC Amp board. See “Installing the TC Amp board” on page 241 33. Reinstall the head board. See “Installing the head board” on page 238 35. Reinstall the substrate sensor. See “Installing the substrate sensor” on page 222 36. Reinstall the toggle head assembly. See “Installing the toggle head assembly” on page 217 37. Reinstall the toggle sensor. See “Installing the toggle sensor” on page 226 38.
Install the 2 XY table alignment brackets to the center of the Y guide rods. See Figure 266. 39. Adjust the alignment brackets as needed. 40. Using a 1 ⁄ 8 ” allen wrench, tighten the alignment bracket adjustment screws. Figure 266: XY Table alignment bracket center mounting location Center the alignment brackets 41. Move 1 alignment bracket to the front of the printer. See Figure 267. 42. Move the translator to the center of the XY table. 43. Move 1 alignment bracket to the rear of the printer. See Figure 267. -294