12. Push the left side Y guide rod in towards the back of the printer. 13. Rotate the left side Y guide rod towards the left side of the printer and raise the guide rod to the top of the frame. 14. Lower the left side Y guide rod into its mounting location. 15. Using a 5 ⁄ 32 ” allen wrench, loosely reinstall the left side rear Y guide rod mounting screw. 16. Using a 5 ⁄ 32 ” allen wrench, loosely reinstall the left side front Y guide rod mounting screw. 17. Reconnect the Y home sensor cable. 18. Align the right side Y guide rod with the mounting holes. 19. Using a 5 ⁄ 32 ” allen wrench, loosely reinstall the right side rear Y guide rod mounting screw. 20.
Using a 5 ⁄ 32 ” allen wrench, loosely reinstall the right side front Y guide rod mounting screw. 21. Align the X guide rods with the mounting holes. 22. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, loosely reinstall the right side X guide rod mounting screws. 23. Align the X motor energy chain mounting bracket with the mounting holes. 24. Using a 5 ⁄ 16 ” nut driver or standard screwdriver, reinstall the 2 X motor energy chain mounting screws. 25. Reconnect the X motor cable. 26. Reinstall a wire tie around the X motor cable connector. See Figure 265. Figure 265: X motor wire tie locations Reinstall wire tie 27. Place the right side Y belt into the retaining clip. 28.
Place the left side Y belt into the retaining clip. 29. Slide the translator to the back of the printer. -293