Z Motor Required Tools • 5 ⁄ 16 ” nut driver or standard screwdriver. • 3 ⁄ 32 ” allen wrench. • 9 ⁄ 64 ” allen wrench. • Cutters Hardware • Wire ties (x2) • 10-32 x 3 ⁄ 8 ” slotted screws (x4) • 4-40 x 1 ⁄ 4 ” slotted screws (x8) • #4 Splitlock washer (x4) • #4 SAE washer (x4) Removing the Z motor 1. Remove the top panel. See “Removing the top panel” on page 161 2. Remove the side panels. See “Removing the side panels” on page 162 3. Remove the upper electronics bay cover. See “Removing the upper elec- tronics bay cover” on page 173 4. Remove the electronics bay. See “Removing the electronics bay” on page 175 5.
Using a 5 ⁄ 16 ” nut driver or standard screwdriver, remove the 4 Z stage panel mounting screws and remove the Z stage panel. See Figure 302. -321