HP — Installing the Z motor

Installing the Z motor 1. Place the Z motor in its mounting location and loosely fasten the mounting screws with a 3 ⁄ 32 ” allen wrench. 2. Insert the leadscrew and turn clockwise until the leadscrew clears the bottom of the motor. 3. Raise the Z stage to the upper limit and tighten the leadscrew mounting bracket set screws. 4. Lower the Z stage down to its lower limit and tighten the Z stage motor mounting screws. 5. Align the Z stage motor energy chain and fasten the mounting screws, be sure not to overtighten and crush the energy chain. 6. Attach and tighten the wire ties on both ends of the Z motor wire. Figure 307:

Remove the Z motor energy chain Reinstall the wire tie Reinstall the wire tie 7. Reinstall the Z stage panel and tighten the 4 mounting screws with a 5 ⁄ 16 ” nut driver or standard screwdriver. 8. Reinstall the electronics bay. See “Installing the electronics bay” on page 176 9. Reinstall the upper electronics bay cover. See “Installing the upper elec- tronics bay cover” on page 174 11. Reinstall the top panel. See “Installing the top panel” on page 162 10. Reinstall the side panels. See “Installing the side panels” on page 164 -324