HP — Installing the Z stage

33. Raise the Z Stage until it contacts the dial indicator. Continue to raise the Z stage approximately two additional revolutions of the dial indicator. Wedge a screw driver or similar object between the underside of the table and the bottom of the chamber to prevent the Z stage from moving downward. 34. Move the dial indicator to the back left (BL) corner and zero the dial indicator. 35. Move the dial indicator to the front left (FL) corner and write down the value. 36. Move the dial indicator to the front right (FR) corner and write down the value. 37. Move the dial indicator to the back right (BR) corner and write down the value. 38.

Enter the values that are written down into the XY level worksheet. Use the 8x6 worksheet for HP Designjet 3D, see Figure 316. Use the 8x8 worksheet for HP Designjet Color 3D, see Figure 317. -332