HP — Performing part based calibration for HP Designjet 3D from the Service Calibration menu (Firmware version 9.1 or newer)

Figure 334: Measuring diameter of circle D 22. Add the lengths derived from steps 20 and 21 (C-D and D-E) and then subtract the width of circle D derived from step 22. Record this total as “GLR” 23. Measure and record the distance from the outside edge of the small bump on circle A to the outside edge of circle D. See Figure 335 Figure 335: Measuring distances from outside edges of A and D 24. Measure and record the distance from the outside edge of the small bump on circle G to the outside edge of circle D. See Figure 336 -349