Figure 336: Measuring distances from outside edges of D and G 25. Measure and record the diameter of circle D along the center line between A and G. See Figure 337 Figure 337: Measuring diameter of circle D 26. Add the lengths derived from steps 24 and 25 (A-D and D-G) and then subtract the width of circle D derived from step 26. Record this total as “GLF” 27. Enter the Service Calibration menu by pressing the following button sequence on the display panel: 3,2,3,3,1 . See Figure 322. 28. Press the Edit Configuration button. 29. Press the GLeft button. Enter the value recorded from step 18 by press- ing the Increment , Decrement and Next Digit buttons. 30. When finished, press Done...
-350 NOTE: The value for GLeft must be between 5.250” and 5.750”.