HP — Performing part based calibration for HP Designjet 3D with the HP Designjet 3D Diagnostic Software

Figure 349: Measuring diameter of circle D 23. Add the lengths derived from steps 20 and 21 (C-D and D-E) and then subtract the width of circle D derived from step 22. Record this total as “Left Rear” 24. Measure and record the distance from the outside edge of the small bump on circle A to the outside edge of circle D. See Figure 350 Figure 350: Measuring distances from outside edges of A and D 25. Measure and record the distance from the outside edge of the small bump on circle G to the outside edge of circle D. See Figure 351 -357