HP — Performing part based calibration for HP Designjet Color 3D from the Service Calibration menu (Firmware version 9.1 or newer)

Performing part based calibration for HP Designjet Color 3D from the Service Calibration menu (Firmware version 9.1 or newer) 1. While the printer is at Idle , enter standby mode by pressing the Standby... button. 2. Enter the Service Calibration menu by pressing the following button sequence on the display panel: 3,2,3,3,1 . See Figure 354. Figure 354: Service Calibration button sequence Button 0 Button 1 Button 2 Button 3 4. The printer will ask “Do you want to zero settings and reboot?” Press Yes . 3. Press the Reset Part Based Calibration button. 5. Reboot the printer. 6. Once the system displays Idle, press Maintenance>System>Test Parts then select the test_XY_cal part. 7.

When part is completed, remove from printer and let cool for five min- utes. 8. Locate the filled circle, this indicates the front of the substrate, see Figure 355 -360