HP — Performing part based calibration for HP Designjet Color 3D from the Service Calibration menu (Firmware version 9.1 or newer)

Figure 355: Locating the Filled Circle (B) 9. Using a digital caliper, measure and record the diameter of circle B along the center line between A and C. See Figure 356 NOTE: Reference letters are not actually “printed” on the part. If needed, use the Part Measurement Equations sheet to record the values. See “Part Measurement Equations” on page 380. Figure 356: Measuring diameter of B 10. Next measure and record the distance from the outside edges of circle A and B, see Figure 357 Ensure that the caliper is not seated on the small bump of circle A. -361