HP — Performing part based calibration for HP Designjet Color 3D from the Service Calibration menu (Firmware version 9.1 or newer)

Figure 363: Measuring distances from outside edges of D and G 19. Measure and record the diameter of circle D along the center line between A and G. See Figure 383 Figure 364: Measuring diameter of circle D 20. Add the lengths derived from steps 18 and 19 (A-D and D-G) and then subtract the width of circle D derived from step 20. Record this total as “GLeft” 21. Measure and record the distance from the outside edge of circle G to the outside edge of circle H. See Figure 384 Figure 365: Measuring distances from outside edges of G and H -365