HP — Performing part based calibration for HP Designjet Color 3D from the Service Calibration menu (Firmware version 9.1 or newer)

22. Measure and record the distance from the outside edge of circle H to the outside edge of circle I. See Figure 385 Figure 366: Measuring distances from outside edges of H and I 23. Measure and record the diameter of circle H along the center line between G and I. See Figure 386 Figure 367: Measuring diameter of circle H 24. Add the lengths derived from steps 22 and 23 (G-H and H-I) and then subtract the width of circle H derived from step 24. Record this total as “GRear” 25. Measure and record the distance from the outside edge of circle C to the outside edge of circle E. See Figure 387 -366