Head Alignment Procedure This procedure is used verify and correct head alignments when misalignment is suspected. NOTE: This procedure must be accomplished in its entirety and in the order presented. The procedure consists of 3 procedures: Drive wheel alignment, Idler Wheel adjustment and Liquefier alignment. Figure 405: Special Head Alignment Tools Shim set Spring removal tool Spring removal tool Drive wheel alignment rod Drive wheel alignment rod Drive wheel alignment rod Liquifier alignment rod Liquifier alignment rod Liquifier alignment rod Shim set Shim set Spring removal tool Drive Wheel Alignment This procedure axially aligns the Head Motor Drive Wheel with the filament path. 1.
Remove the Pivot Block Spring using spring removal tool. See Figure 406 Figure 406: Pivot block spring location Pivot Block Spring Tool 2. Remove the right side Pivot Block. • Remove the retaining clip and teflon washer from the right side Pivot Block Pin. 3. Move the Toggle Bar to the right. 4. Loosen (don’t remove) the model side Heater Block Mount screws and the model side Heater Block Clamp screws -392