HP — Drive Wheel Alignment

5. Make sure that the Drive Wheel Alignment Rod is straight. Roll the Rod along a flat surface to check for bends. Straighten as necessary. 6. Insert the Drive Wheel Alignment Rod from the bottom of the right side (model) heater block (before using, check the rod to make sure that it is straight). 7. Push the Alignment Rod up into the Main Pivot Block. 8. Position the Alignment Rod so that the stepped portion is centered between the Heater Block and the Pivot Block. See Fig. 407 9. Tighten the Heater Block Clamp screws. 10. Tighten the Heater Block Mount screws. Figure 407: Drive wheel alignment Toggle Bar to right.Alignment Pin inserted so ‘step’ is visible.

Drive Wheel set screw Toggle Bar to left. Drive Wheel is positioned so that Alignment Pin is centered in Wheel track. Heater Block Mount Screws Heater Block Clamp Screws 11. With the Drive Wheel set screw loose (make sure that the Drive Wheel is free to slide axially on the Motor shaft), gently move the Toggle Bar to the left until the Alignment Rod rests in the groove of the Drive Wheel. NOTE: Do not force the Toggle Bar to the full left position. Forcing the Toggle Bar to the full left position may cause the Alignment Rod to bend. 12. Adjust the Drive Wheel until the Alignment Rod is centered in the groove of the Drive Wheel. 13. Tighten the Drive Wheel set screw. 14.

Verify proper Drive Wheel alignment: A. Gently move the Toggle Bar to the right, then back to the left while observing the Drive Wheel and Alignment Pin. • View the alignment of the Drive Wheel and Alignment Pin from the right side of the system. -393