HP — Idler Wheel Check/Adjustment

F. If the tension is not correct remove the Idler Wheel Tension Adjust screw (5/64” Allen), apply LocTite 222 to the screw threads, and install the screw. G. Adjust the screw to obtain a light drag on .003 inch feeler gauge when it is positioned between the Drive Wheel and the Idler Wheel. H. Check the tension with the .005 inch feeler gauge as above. I. Continue to adjust the screw until the prescribed tension is obtained. J. When adjustment is complete, place the Toggle Bar in the Neutral position, and remove all feeler gauges. K. Place the Toggle Bar in the full Left position and spin the Idler Wheel by hand. The Idler Wheel should spin freely without drag.

If drag is present, re-check adjustments. Figure 411: Idler Wheel Adjustment - Right Side Right side Idler Wheel Tension Adjust screw. Drive Wheel rotated so set screw head is on the bottom. Use .003 inch and .005 inch feeler gauges (shim stock) to check clearance. 3. Check/Adjust the Left (Support) side Idler Wheel clearance: ( Figure 412 ) A. Move the Toggle Bar to the full Right position. B. Check/Adjust the clearance between the Drive Wheel and the Idler Wheel - a .003 inch feeler gauge (shim stock) should have a light drag when placed between the Drive Wheel and the Idler Wheel. C. Place the Toggle Bar in the Neutral position. D.

Insert a .005 inch feeler gauge between the Drive Wheel and the Idler Wheel. E. Return the Toggle Bar to the full Right position - the .005 inch feeler gauge should be firmly held between the Drive Wheel and the Idler Wheel. -396