HP — Complete the Re-Assembly of the Toggle Head Assembly

Figure 416: Liquefier alignment check (2 of 2) Unacceptable liquefier alignment Pinch point is the same as the centerline of the alignment rod. Complete the Re-Assembly of the Toggle Head Assembly 1. Connect the Filament Tubes to the top of the Toggle Head Assembly - make sure the model tube is on the right; the support tube on the left. 2. Install the Air Plenum - connect the Plenum to the air duct at top - press in on clips to fit the plenum to the Translator. 3. Install the Head Cover - squeeze the side tabs to fit the Translator. 4. Power the printer up. 5. From the display panel, press Maintenance > System > Tips and perform the following calibrations: A. Z calibration B.

XY Tip offset calibration. NOTE: Follow the Head Installation Checklist after completing Toggle Plate Assembly replacement. -401