Tip wipe assembly If the XY Table or Z stage has been replaced or leveled, the tip wipe assembly will need to be adjusted to ensure proper functionality. Required Tools • Standard screwdriver • 7/64” allen wrench • Tip wipe height block Adjusting tip wipe assembly height: 1. Remove tip wipe assembly by pulling out of tip wipe bracket. See Figure 417 2. Remove the plastic screw caps by prying apart with a standard screw- driver. See Figure 417 Figure 417: Tip wipe assembly location 3. Insert the tip wipe assembly height block into the tip wipe assembly bracket. See Figure 418 Figure 418: Tip wipe assembly height block -402