HP — Connect

Send Calibration The Send Calibration button allows you to send the complete set of factory calibrations to the printer as a single file. This includes but is not limited to: Tip Offset, Tip Depth, YLash, X Correction, and the gantry DAT file. A calibration file can be retrieved from the modeler using Get Calibration . When this button is pressed a dialog box appears that allows you to browse for and select the calibration file to send to the printer. Get Configuration Clicking the Get Config button will download the configuration file from the printer. Test Parts Test Parts consists of downloading sample and test part files to the printer.

The files must be in the .cmb.gz format produced by HP Designjet 3D Software Solution. The Test Part dialog allows you to browse for and select the sample or test file and to download it to the printer. The Test Parts are not preserved during a software upgrade. To remove unwanted test parts, upgrade the software to the current level and only the factory test parts will remain on the system. Reset Password This button resets the administrator password to null. This turns off password control of the queue. This is used for clearing a forgotten password.

Connect If the system is not available over the network, when HP Designjet 3D Diagnostic Software first loads, HP Designjet 3D Diagnostic Software will only try to connect one time. This allows you to interact with HP Designjet 3D Diagnostic Software when it is not connected to a printer. The Connect button allows you to request additional connection attempts. -430