HP — Get Calibration

Outputs The outputs dialog contains toggle buttons to control solenoids and motors that can not be directly controlled on the Control Panel Display. NOTE: It is suggested, that due to the time required to display switch state changes, that you use the LEDs on the PDB to verify switch operations. Get Calibration The Get Calibration button allows a single calibration file to be retrieved from any printer. This calibration file will also be on the printer Frame ID chip. This file contains all the factory calibration information, including, but not limited to: Tip Offset, Tip Depth, Y Lash, X Correction, and the table calibration .DAT file.

When the button is pressed, a file selection dialog is presented allowing the assignment of a file name and the selection of a storage location. This file should be updated any time maintenance is performed that affects the factory calibration. -429 Model Latch The check box shows the state of the model (top) cartridge latch. Checking or unchecking the toggle button enables or disables the latch. Motor Enabled The check button shows the state of the model (top) feed motor solenoid. Checking or unchecking the toggle button enables or disables the solenoid. Motor Running The check box shows the state of the model (top) filament feed motor.

Checking or unchecking the toggle button enables or disables the motor. Support Latched The check box shows the state of the support (bottom) cartridge latch. Checking or unchecking the toggle button enables or disables the latch. Motor Enabled The check box shows the state of the support (bottom) feed motor solenoid. Checking or unchecking the toggle button enables or disables the solenoid. Motor Running The check box shows that state of the support (bottom) filament feed motor. Checking or unchecking the toggle button enables or disables the motor. Door Latch This check box shows the state of the door latch solenoid. Checking or unchecking the toggle button enables or disables the latch.

Lights On This check box shows the state of the chamber lights. Checking or unchecking the toggle button enables or disables the lights.