The MZ command moves the Z-Stage relative to the current position. A positive value moves the Z-Stage down. A negative value moves the Z-Stage up. Example: mz 4.0 This command will move the Z-Stage 4 inch down. 10. mx = move x This command moves the head in the X axis. Parameters: Float Position: This is the absolute position it moves to, in inches, when the command is sent from the Console and in device units when the command is sent through the DPM. Example: mx 3.0 (moves the X-Axis 3 inches away from the X-Home sensor) 11. my = move y This command moves the head in the y axis. Parameters: Float Position:
This is the absolute position it moves to, in inches, when the command is sent from the Console and in device units when the command is sent through the DPM. Example: my 3.0 (moves the Y-Axis 3 inches away from the Y-Home sensor) This command turns the chamber light on and off. 12. cl = chamber light Example: cl 1 Parameters: Command Description cl 0 Turns the light off cl 1 Turns the light on 13. dl = door latch This command controls the door latch solenoid. The door latch can be opened or closed. Example: dl 1 Parameters: Command Description dl 0 Opens door latch dl 1 Closes door latch dl 2 Places controller in charge of door latch -441