HP — Installing Firmware on printer

Installing Firmware on printer 1. From the display panel, press Maintenance . 2. Press System . 3. Press Load Upgrade . “Send upgrade from workstation” and the printer IP address will be displayed. 4. From your workstation, open the HP Designjet 3D Software Solution by double clicking on the HP Designjet 3D Software Solution icon. 5. Click the Printer Services tab. 6. Select your printer from the drop down list then click the Update Soft- ware button. 7. Navigate the HP Designjet 3D Software Solution to the directory where the firmware file is located and select the HP Designjet 3D.upg file for HP Designjet 3D or select the HP Designjet Color 3D.upg file for HP Designjet Color 3D.

Firmware will now begin to download to the printer. NOTE: The printer will not allow a firmware upgrade file for a different type of printer. If an upgrade file that is incorrect, “Upgrade - Invalid Upgrade” will be shown on the display panel. 8. When firmware verification is complete, the printer display will show Reboot to complete upgrade ? Press Yes . The printer will then load the firmware then reboot and return to Idle . -30 NOTE: Loading firmware will take approximately 10 minutes.