Adding the second HP Designjet 3D Material Bay You have the option of adding a second material bay to extend printing times without having to reload material while the model is printing. Installing the HP Designjet 3D Material Bay: 1. Remove the HP Designjet 3D Material Bay, material bay cable, material spools and material carriers from the box. 2. Unload the model and support material from the printer. 3. Open the material bay doors by gently pressing in to release and pull- ing outwards. 4. Remove the material carriers by first pushing them in to unlatch and then pulling them outwards. 5. Place the carriers on a flat stable surface. CAUTION:
Do not push the material through the material guide back into the carrier, doing so can cause material to break or become tangled. 6. Open the carriers. 7. Rotate the spools to rewind the material, leaving 2 inches (50mm) remaining at the material guide. See Figure 15. Figure 15: Rewinding the material spool 8. Using a cutters, cut the excess 2 inches (50mm) of material from the material guide. leaving a blunt end. 9. Power the printer off at the power switch. 10. When the printer has powered down, switch the circuit breaker to the OFF position. 11. Disconnect the power cable, network cable, material bay cable and UPS cable if used. 12.
Disconnect the model and support material tubes from the printer and the material bay by pressing in on the coupler ring and pulling the tubes outward. 13. With 2 people, use the handgrips to lift the printer off of the material bay and place on a flat stable surface. See Figure 16. -31