HP — Installing the HP Designjet 3D Material Bay:

Figure 18: Positioning printer 16. Remove the black plugs from the model and support Y blocks by push- ing in on the coupler rings and pulling outward. See Figure 19. Figure 19: Removing the Y block plugs 17. Connect the short red striped material tube (M1) from model (M) coupler of upper material bay to left side of model Y block by inserting firmly into red couplers. Gently pull the tube to ensure it is properly inserted. 18. Repeat with the short black striped (S1) material tube for support side. See Figure 20. -33