HP — Installing the HP Designjet 3D Material Bay:

Figure 20: Connecting the short material tubes 19. Connect the long red striped material tube (M2) from model (M) coupler of lower material bay to right side of model Y block by inserting firmly into red couplers. Gently pull the tube to ensure it is properly inserted. 20. Repeat with long black striped (S2) material tube for support side. See Figure 21. Figure 21: Connecting the long material tubes 21. Connect a material bay cable between the printer and the top connector on the upper material bay. 22. Connect the other material bay cable between the bottom connector of the upper material bay to the top connector of the lower material bay. See Figure 22. -34