HP — Installing the HP Designjet 3D Material Bay:

Figure 22: Connecting the material bay cables 23. Connect the power cable, network cable and UPS cable if used. 24. Switch the circuit breaker to the ON position. 25. Power the printer ON at the power switch. 26. After the printer has booted up, you may need to reload the printer firm- ware. If the printer displays “ Send Upgrade from Workstation ”, See “Updating printer firmware:” on page 53. 27. Insert model and support material spools into the new material carriers. 28. From display panel press Material . Display will show Add/Remove . 29. Open material bay doors and push both red handled model carriers into right side of the material bays until they latch. 30.

Push both black handled support carriers into left side of the material bays until they latch. 31. Press Load Selected . The printer will load the first material bay and pre- pare the second material bay for automatic loading. When the printer has finished loading material, S1 and M1 will be marked with asterisks. All material bay LED’s will be solid. 32. When finished loading material press Done. Display will show Idle and amount of material remaining for model and support in both material bays. -35 NOTE: Material may take up to ten minutes to load.