The display panel during build The top two lines of the display panel will show the printer status. See Figure 26. The bottom line of the display panel will show the amount of model and support material that remains in the carriers. Figure 26: Display panel during build Single material bay Printer status Support material remaining Model material remaining Model file name Dual material bay Printer status Model file name Support material remaining in bay 1 Model material remaining in bay1 Model material remaining in bay2 Support material remaining in bay 2 NOTE: If a material amount is flashing, it indicates that the remaining material will not be enough to complete the current build.
Chamber Lights When a part starts to build, the chamber lights are automatically ON. The default time-out for the lights is 30 minutes. You can toggle the lights ON or OFF through the display panel. You can set the chamber lights on permanently, however the chamber lights will return to factory settings when power is cycled. 1. From Idle or Ready to Build , on the display panel press Maintenance . 2. Press Setup . 3. Press Lights Always On . Repeat this process to turn this option off. -44