HP — Canceling a build

Pausing a build While building a part, you may want to pause the build to allow for material replacement. To pause the build at any time, from the display panel press Pause . NOTE: The printer will complete the current tool path before pausing. Resuming after pause If you have pressed Pause , and are ready to resume building the part, press Resume and the printer will resume printing. Canceling a build You can cancel a build at any time while the part is building. 1. From the display panel press Pause . 3. The display will ask Are you Sure? Press Yes . 2. Once the printer stops building, press Cancel Build . 4. The display will show Build Stopped followed by the file name.

You will then be prompted to remove the part and replace the modeling base. 5. Remove the part and replace the modeling base. GLOVES: The modeling base will be hot, wear gloves when removing the part from the printer. 6. Once the chamber door has been opened and closed, the display will ask Part Removed? Press Yes ONLY after you have removed the part and replaced the modeling base. CAUTION: If you press Yes before removing the part, the printer can be damaged. -45