Removing a completed part When the printer has completed building a part, the display will show Completed followed by the file name. It will also show Remove Part and Replace Modeling Base . GLOVES: The modeling base will be hot, wear gloves when removing the part from the printer. 1. Open the chamber door. 2. Turn the modeling base retainers down and remove the modeling base by sliding out and pulling up. 3. Insert a new modeling base by sliding in and pushing down, turn the retainers up to lock the modeling base in place. 4. Close the chamber door. 5. After you have opened and closed the door, the display will show Part Removed?
ONLY after removing the part and replacing the modeling base, from the display panel press Yes . After you press Yes , the display will show the status as Idle or Ready to Build for the next part in the queue. Remove a part from the modeling base: 1. After removing the modeling base from the printer, firmly flex the modeling base back and forth with your hands to loosen the part. 2. Pull the part off of the modeling base or use a putty knife to completely remove the part. NOTE: Parts are easier to remove from the modeling base when still warm.
Removing support material HP Designjet 3D and HP Designjet Color 3D use soluble support material which is designed to dissolve in a soap and water based solution. Your part is left with a smooth and clean finish with the fine details intact. The soluble support material can be removed by hand with relative ease, but is designed to be dissolved from your parts for hands free finishing. WARNING: Support material is sharp, wear safety glasses and gloves when removing support material. -46 CAUTION: If you press Yes before removing the part, the printer can be damaged.