11. Cut the excess material from material guide. 12. Place the material retaining clips on the spool before removing the spool from the carrier. See Figure 33. A. Push the material retaining clips over the material and clip on to the material spool. B. Push the material retaining clips down until they lock in place. Figure 33: Installing material retaining clips Place clip and push down to lock in place 13. Remove the material spool from the material carrier. See Figure 34. Figure 34: Properly installed material retaining clips. 14. Place the material spool in the storage bag that came with the material carrier. NOTE:
When not loaded in the printer, always store material spools in the material carrier or the storage bag that came with the carrier to prevent moisture absorption. Auto power down You can set the printer to automatically power down when a build is complete. This option will save energy usage. 1. While the printer is building, press the Auto Power Down button. 2. Turn the power switch, located on the left side of the printer, to the OFF position. The printer will display Auto Power Down Mode and the printer will power down as soon as the build is complete. Cancelling auto power down: 1. Turn the power switch back to the ON position. -52