HP — Installing the firmware:

Powering off To power off the printer, turn the power switch to the OFF position. You can do this at anytime without harming the printer. No other steps are necessary. If this is done while the printer is building a part, the current part will not be completed. NOTE: System cooling fans and lights will continue to operate for several minutes after the switch has been turned off. Resuming operations from Standby mode After several minutes of inactivity, the printer will enter Standby mode. During Standby, the head temperature will decrease to conserve energy. From the display panel press Resume . Updating printer firmware: Check http://www.hp.com for printer firmware updates.

If there is an upgrade to the printer firmware, download the upgrade and install on the printer. Installing the firmware: 1. From the printer display panel, press Maintenance . 2. Press System . 3. Press Load Upgrade . The printer will then display “ Send upgrade from workstation ” followed by the printer’s IP address. 4. Open HP Designjet 3D Software Solution and click on the Printer Ser- vices tab. 5. Click on the Update Software button. HP Designjet 3D Software Solution will now connect to the printer and will prompt you to locate the upgrade file. Navigate HP Designjet 3D Software Solution to the direc- tory where the upgrade file is located.

The update will automatically be loaded on to the printer. After the update has been loaded, the display will show Verifying update . 6. When verification is complete, the display will show Reboot to complete . Press Yes . The printer will now reboot and return to Idle . 7. Press the Maintenance button and verify the updated version was installed correctly then exit maintenance. -53