Software Software Architecture (Figure 35) shows the major software components that control the system. The software that runs on the controller board is EPROM based. The software that runs on the SBC (single board computer) is stored on the hard drive and loaded during power up. Like all workstation compatible computers, the SBC runs a brief self-test on power up and then loads the operating system followed by the system’s application components. Figure 35: Software Architecture Diagram Operating System The printer’s software currently runs on RedHat Linux. The operating system is multi tasking allowing the software components to run fairly independently.
The operating system also provides support for the TCP/IP network interface and the hard drive. Display Driver This software interacts with the operator display panel on the front of the system. This software processes all button pushes. The driver also formats the information going to the four line display and the context sensitive button labels. -55