HP — Removing tips:

Figure 48: Head cover tab locations Press tabs in to remove head cover Head cover 9. Remove tips A. Use 7/64 T-Handle Allen wrench to loosen the heater block screws three to four full turns counterclockwise - or until the top of the screws are flush with the metal cover. DO NOT remove the screws entirely. See Figure 49. Figure 49: Tip Removal Loosen but do not remove heater block screws Loosen but do not remove heater block screws B. Use needle nose pliers to grasp the stainless steel shield of the tip. C. Pull the tip shield toward you, then pull down to remove the tip from the heater block. Discard the used tip. See Figure 50. -67