HP — Removing tips:

2000 Hour maintenance Tip replacement and calibration A Preventive Maintenance Alert will be displayed after 2000 hours of run time informing you that tips need to be replaced and calibrated. See Figure 47. Figure 47: Preventive Maintenance Alert NOTE: Tips can also be damaged by improper care while performing maintenance in the area around the tips. HP Designjet 3D Software Solution displays the tip time (hrs) - from the Printer Services Tab - Printer Info button (Tip time will reset to zero after replacement). Removing tips: 1. You will need to make sure the printer is powered ON before replacing the extrusion tips. 2. From the display panel press Maintenance. 3. Press Machine. 4.

Press Tip . 5. Press Replace . 6. The printer will display Load Model - Unloading. 7. You can now open the printer door and replace the tips - or you can Cancel the tip replacement procedure. 8. Remove plastic head cover by squeezing raised pads on sides of cover. See Figure 48. -66