Figure 45: Filament Present Switch location Support side Filament Present Switch Model side Filament Present Switch 6. Obtain a can of compressed air. 7. Insert the canned air extension tube to its spray nozzle. 8. Align the canned air extension tube with the entrance hole of the Fila- ment Present Switch. See Figure 46. Figure 46: Cleaning the Filament Present Switch 9. Squeeze the spray nozzle for one quick burst (approximately 2 seconds) to clear each Filament Present Switch on the model and support sides of the material bay. If an optional material bay is installed, repeat this pro- cedure for the second bay. 10. Reconnect the material tubes to the rear of the material bay(s). 11.
Replace the material carriers and load material. -65