Figure 44: Tip Shield installation 6. Exit Maintenance , press Done until back at Idle . Remove debris from the Filament Present switch There may be a time when the Filament Present switch needs to be cleared in addition to the 500 hour maintenance. For example, if a Material Error- Filament blocked message appears on the display panel; the recommendation may be to clear debris from the Filament present switch. 1. Unload material from the printer and remove the material carriers. 2. Open the material bay doors by gently pressing in to release and pull- ing outwards. 3. Remove the material carriers by first pushing them in to unlatch and then pulling them outwards. 4.
Disconnect the material tubes from the rear of the material bay(s). Leave them attached to the Y block. 5. Locate the entrance hole to the Filament Present Switch in the material bay(s). See Figure 45. -64