Troubleshooting User Troubleshooting -75 Problem Recommendation No power 1. Verify power cord is securely plugged in. 2. Verify that the circuit breaker (at rear of printer) and the power switch (on left side panel of printer) are both in the ON posi- tion. 3. Verify AC power is present at wall outlet, i.e. plug a known good item into outlet. Material not extruding Material may be clogged in tip. See “Clogged tip” on page 79. Purge material accumulating on part. Check condition of tip wipe assembly. Replace if worn. No text displayed on Display Panel Cycle power. Cannot communicate with printer through network or crossover cable 1.
Make sure network cables are connected - at the printer, at the PC, or where cables connect to network hubs. 2. Re-configure network settings. 3. If using a static network address, verify that the IP address entered in HP Designjet 3D Software Solution matches the IP address entered in the printer. 4. Your network configuration may have changed. Contact your Network Adminis- trator. Error code displayed on display panel Record error code and reboot printer. If error code repeats, contact Technical Support. For more information, refer to“Fault determination codes” on page 77. Build Error Partial or bad part file sent to printer.
Check STL file in CAD software for errors; reprocess STL in HP Designjet 3D Software Solution and re-download to printer.