NOTE: Certain Filament related error messages will allow you to enter maintenance mode after a 30 second timeout. Fault determination codes If a fault occurs which would prevent the printer from executing an operator request, the printer will begin to shut down and cool. The panel will display an error code. An error-code list (with the filename “error.txt”) can be found on the DVD-ROM for the printer firmware. (Because this list may change with each new software version, be sure to check the error.txt attachment when you download new firmware upgrades.) After the printer has finished cooling, the only option displayed is Continue .
Press Continue and the printer will reboot and try to return to normal operation. If pressing Continue does not eliminate the error, power should be cycled (see “Cycling power” on page 78.. ); wait 60 seconds before switching power on again. In most cases you will be able to continue operation. However, if the printer continues to shut down and display the same error, contact technical support. -77 Error message on display panel Recommendation Load Error Purge failed 1. Remove the carrier and verify material is coming out of the material guide. 2. Verify the material pulls freely from the carrier. 3. Verify the material tubes are free of mate- rial. 4.
Check for and clear any excess material build up around the tips. Unload Error Unload failed Remove the carrier and verify the material tubes are free of material. Model/Support Jam in head clear before resuming See “Material Jam” on page 80. Pausing 1. Press Resume. 2. Unload the material carriers and reinstall. Model/Support Jam in head clear before resuming See “Material Jam” on page 80. Can’t Find Home – Check Modeling Base 1. Verify a modeling base is inserted. 2. Modeling base may be used or defective – replace.