HP — Clogged tip

10. Determine if there is a support material extrusion problem by pressing Forward . Watch the support tip (left tip) for any extrusion (material purge). 11. Press Stop to stop the extrusion. 12. If material did NOT flow from the support tip, see “Recovering from loss of extrusion” on page 82. If material steadily flowed from the support tip, the support tip is functioning properly. 13. Return the printer to the Maintenance state - Press Done , then press Yes when the printer displays Is Material Loaded? 14. Press Done until back at Idle . Clogged tip Occasionally, a tip may clog with material. This will often result in a loss of extrusion (LOE).

A clogged tip will prohibit material load and part building. 1. Remove the head cover by pressing the tabs in and pulling away from the head. See Figure 56. GLOVES: The head area is hot. Use gloves when working in this area of printer. Figure 56: Remove the head cover Press tabs in to remove head cover Head Cover 2. Inspect top of tips for material build up. If there is excess material build up see “Recovering from loss of extrusion” on page 82. If there is no excess material build up close the chamber door and continue. 3. From the display panel press Maintenance . 4. Press Machine. The printer will calibrate which will take approximately 3 minutes. -79