HP — Material Jam

5. Press Head. The head will heat up to operating temperature which will take approximately 3 minutes. 6. Press Select Drive and choose the drive that may have the clogged tip. 7. Press Forward , the drive wheel will turn the selected drive forward. 8. Press Blower Off , this will turn the head cooling fan off for 10 seconds, allowing the tip to heat up beyond operating temperature. If material starts to extrude the tip is no longer clogged. If material does not extrude see “Recovering from loss of extrusion” on page 82. 9. Press Done . 10. Display will ask Which Materials Loaded? Press Both. 11. Press Done until back to Idle .

Material Jam Occasionally, material may become jammed in the head. The printer will notify you of a material jam through a message shown on the display panel. If a material jam is detected, follow these steps to clear the jam. 2. Press Maintenance . 1. From the display panel, press Continue . 3. Press Machine . 4. Press Head . 5. Once in head maintenance mode, remove the head cover by pressing the tabs in and pulling away from the head. See Figure 57. GLOVES: The head area is hot. Use gloves when working in this area of printer. Figure 57: Remove the head cover Press tabs in to remove head cover Head Cover -80