6. Inspect tip inlets for material build up see Figure 58. If there is excess material build up see “Recovering from loss of extrusion” on page 82. If there is no excess material build up close the chamber door and con- tinue. Figure 58: Tip inlet locations Model tip inlet Support tip inlet 7. Press Select Drive and choose the drive that may have the clogged tip. 8. Press Forward , the drive wheel will turn the selected drive forward. 9. Press Blower Off , this will turn the head cooling fan off for 10 seconds, allowing the tip to heat up beyond operating temperature. If material starts to extrude the tip is no longer clogged.
If material does not extrude see “Recovering from loss of extrusion” on page 82.. If material extrudes, you can continue building your part. 10. Reinstall the head cover. NOTE: If the head cover is not replaced the printer may not function properly. 11. Press Done . 12. Display will ask Which Materials Loaded? Press Both. 13. Press Done until back to Pause screen. Press Resume to continue building the part. -81